Area and power consumption are the most important parameters in integrated bio-potential signal amplifier with low noise and low bandwidth requirements. In this paper we present an analytical method for optimizing differential amplifiers for a constant input-referred noise level. Power- area optimization is performed over 1mHz to 10kHz in a 0.18μm CMOS technology. The amplifier consumes 22μA from a 1.8V power supply and the total equivalent input-referred noise over that bandwidth is equal to 2.4μVrms. The results, validated by SPICE circuit simulations, indicate that the amplifier can be optimized for specific input-referred RMS noise level.
Madadi, I., Jafarabadi Ashtiani, S., & Masoumi, N. (2013). Optimization of Power and Area in Low-Noise CMOS Bio-Signal Amplifiers. Journal Of Electrical Systems And Signals, 1(1), -. doi: 10.22067/ess.v1i1.17115
MLA
Iman Madadi; Shahin Jafarabadi Ashtiani; Nasser Masoumi. "Optimization of Power and Area in Low-Noise CMOS Bio-Signal Amplifiers". Journal Of Electrical Systems And Signals, 1, 1, 2013, -. doi: 10.22067/ess.v1i1.17115
HARVARD
Madadi, I., Jafarabadi Ashtiani, S., Masoumi, N. (2013). 'Optimization of Power and Area in Low-Noise CMOS Bio-Signal Amplifiers', Journal Of Electrical Systems And Signals, 1(1), pp. -. doi: 10.22067/ess.v1i1.17115
VANCOUVER
Madadi, I., Jafarabadi Ashtiani, S., Masoumi, N. Optimization of Power and Area in Low-Noise CMOS Bio-Signal Amplifiers. Journal Of Electrical Systems And Signals, 2013; 1(1): -. doi: 10.22067/ess.v1i1.17115
)
Send comment about this article